Place the dry and ready-to-use mesh on the coating table, pour a proper amount of the photosensitive glue into the scraper, first apply the printing surface (convex surface of the screen), then apply the ink surface (concave surface of the screen), generally 3 per side Knife times, if thick wire mesh is required, it can be applied in multiple times, that is, after the first gluing, immediately put it into the oven at 30-40 °C for drying, take out the wire and re-apply the glue, according to the required thickness, Decide on the number of times of application, pay attention to the general printing surface (convex surface) to apply 2-3 times more than the ink surface (concave surface).
The gluing process is very important. The quality of the screen is good or bad. It depends on the glue, and the thickness of the plate is required to be uniform and uniform.
