Common problems with screen printing machines
1. Photoelectric detection is unstable
Solution: regularly clean the photovoltaic surface dust, adjust the photoelectric detection sensitivity, special product replacement corresponding to detection photoelectric
2. Unstable ignition does not produce fire
Solution: Use clean gas and compressed air to prevent blockage. Check the line, whether the line is connected due to long-term swing
3. Cylinder movement is not coordinated
Solution: Use clean compressed air to prevent solenoid or cylinder blockage. Adjust the cylinder installation position to avoid misalignment of the cylinder
4.UV system alarm
Solution: Detect the alarm code and view the touch screen prompt scheme according to the alarm code.
5. Solenoid valve does not work
Solution: Check if the solenoid valve is blocked. Check if the voltage of the solenoid valve is normal, and then check the relevant line conditions.
6. Main motor alarm
Solution: first detect whether the inverter has normal operation, whether the voltage is normal, and then detect whether the motor has heat, jitter, whether there is a collision device, causing the stall
7. The air pressure is too low
Solution: Check if the incoming air pressure is lower than 4 kg
8. Emergency stop
Solution: Turn the emergency stop switch on
8.LED overheating
Solution: Whether the waterway has no normal circulation causes no cooling. Is the lamp plug loose?
9. The water level is too low
Solution: Whether the water level of the water tank is lower than the normal water level. Whether the water level detection valve is not connected
10. Online alarm
Solution: Check if there are any warnings on other connections and handle them
